Installation of lighthouses for plaster
In order to get a beautiful result of wall decoration or other surface, work on plastering is always applied. This process has different stages on execution and one of them, this is the installation of a lighthouse. At first glance, this process does not seem difficult, but it has its own implementation points and only if you can adhere to a wonderful result. Install ready -made beacons:
1. Ready beacons are slices of small thickness. They are produced from metal in thickness six or ten millimeters and perforation is performed on them. Before starting the repair, it will not be superfluous to find out that the carpet or linoleum is better.2. Now, using a plumb line and level, the surface is calculated and the place where the lighthouses will be installed is noted. These markings are carried out with a certain step, which depends on the capabilities of a person. If we talk about the work of professionals, then they place beacons about two meters from each other. But if you have not encountered such work earlier, then it will be enough to retreat about one and a half meters.
3. Now a solution of alabaster enters the work. With it, the beacons are attached to the wall. Do not lay it a lot of aborns a few drops so that the rake grabbed. Remember also that the alabaster layer should be even as even, if this is not, then you cannot make an even level of plaster. And in this work it should be perfectly accurate.4. If you need to attach the beacons more carefully, then it is worth using a self -tapping screw.5. After complete completion and before laying the plaster, the level of their location must be checked.